Marble vanity top marble kitchen Worktops | Marble sealing method

Purchase Quality marble vanity top marble kitchen worktops Factory & Manufacturers, Marble sealing method

During the installation process of stone, it is necessary to ensure that the natural texture of the surface is not contaminated, and certain waterproof measures must be taken. Currently, there are three ways to install and seal stone:

1. No sealant is added to the gaps, and air convection is formed on the back of the stone, and water vapor is discharged outside to prevent the temperature difference on the surface of the stone and prevent the inner surface of the stone from condensed water.

2. The semi-sealed sealing type is to keep the façade in a position without sealant. The façade has a good three-dimensional effect and actually hides the glue layer inside the node. To ensure that the thickness of the sealant should be about 6mm, but not more than the width, the width should be calculated based on the quality of the glue.

3. Use neutral sealing silicone glue, which is a special glue for stone, seals all the seams on the facade, and rainwater on the facade cannot enter the back of the stone so that the stone is kept in a dry state to ensure the bending strength and resistance of the stone. The shear strength is unchanged.

In addition, when sealing the stone, it should be noted that the stone also needs to be "breathable". Stone is composed of various crystals, and crystals are composed of various minerals. The crystal structure formed by these minerals determines the type of stone. The integrity of the crystal is closely related to the millions of bacteria in it, and the water in the stone also needs to evaporate to the outside through the gap.

1.we must ensure that these bacteria survive and multiply. After a long study, it was discovered that bacteria seemed to play an important role in keeping the stone intact.

2.When sealing the stone, the sealant is filled in the pores or crystal gaps of the rock and will not flow out of the stone. The purpose of sealing is to prevent liquid penetration and staining.

Also, avoid the use of acrylic sealants or impregnants, because they will block the pores and kill bacteria and completely block the flow of water in the stone. If the inside of the stone becomes wet, it will cause the stone to crack. If the sealant is used too much and is not properly removed, and keep it damp, the stone under the sealant will fade and dim.